Insert ball bearing unit is consisted of a double sealed, single row bearing and one of various types of housings (cast iron or stamping steel housing).

Bearing units structure

Note:

        1. When the fit between bearing and housing is clearance fit, the bearing's outer ring has anti-rotation ball (pin).

        2.Two set screws on the wide inner ring at 120 or 62 degrees apart.

        3.Usually, the outer ring of theXLB bearings has grease groove, bearings having no grease groove are to be provided,too.

The features of products

Rational self-alignment

     The outside diameter of the self-contained bearing is spherical to match corresponding spherical inside diameter of the housing providing self-aligning between these two members, which compensates for misalignments of the units resulted from errors in mounting and distorting of the foundation.

Large load carrying capacity

       Being the same as 6200 and 6300 series single row deep groove ball bearings in internal construction of the self-contained bearings, Insert Ball Bearing Units can substain radial loads and substain thrust loads as well. And they are low noise during operating.

Longer service life

Efficent sealing

We can provide several types of sealings as follows:

3,RST type: It covers the functions of both shield and seal. The rubber lip and inner ring form standard torque contact sealing, these can provide an effective barrier against the entrance of foreign matter such as mud、dust、vapour and leakage of grease. As shown in the figure 3.

Solid housing

The cast iron horsing is of solid one-piece construction to provide maximum rigidity against deformation at mounting and wear resistance to any operating conditions.

Bearing can be locked on the shaft easily.

There are three methods of locking bearing to the shafts. Locking with two set-screws in the extended inner ring is the most common method. Adopting sleeve locking or an eccentric locking collar is also available. All these locking methods and lock the bearing on the shaft easily.

As shown in the figure 4, the inner ring of the self-contained bearing is hardened in the race-way and surroundings part where hardening is necessary, the area of set screw hole of the inner ring has been templed by high temperature after hardened,it has higher toughness and impact clasticity. This special heat-treatment ensures full bearing performance and prevents the set screws from loosening during operation as the set screws can be tightened hard enough without causing broken inner ring set screw hole.

Unique device to prevent bearing’s outer ring rotation

The bearing outer ring is equipped with a unique locking-pin (or ball) which permits automatic selfaligning of the bearing, and also prevent outer ring from rotating. This can prolong bearing's service life.

Complete interchangeability between bearing and housing

Skilled precision workmanship on the self-contained bearing and the housing provides complete interchangeability between them and the bearing can be easily replaced whenever required.

Easy installation

The self-contained bearing is prelubricated with an adequate quantity of high quality grease. Bearing units can be mounted on the shaft immediately. The units are, therefore, free from ingress of harmful contaminants into the bearing chamber during mounting procedures.